matong slot
Matong X
mating slot in the lid and let it dry thoroughly before closing the lid The ½” gasket should form an airtight seal against the sealant in the lid slot
The mating slot in the shaft is machined with an end mill that matches the radius of the shaft key design Once installed the key is contained in the A protrusion on the bottom mounts in a mating slot in the pocket to maintain high edge location precision DROPMILL Artikel # ISC5604767 Blagovna znamka
เศรษฐี99เครดิตฟรี The locating lug on a half shell bearing registers with a mating slot in the housing to locate the bearing shell as shown in Figure 1 below The lug is not 2) Take the module case half with the locking tab and partially insert the tab into the mating slot of the other half 3) At the other end of the module
